Extension Plate for Perun moto Husqvarna 701 Enduro Luggage rack - Installation Instructions

Extension Plate for Perun moto Husqvarna 701 Enduro Luggage rack fits only Perun moto Husqvarna 701 Enduro Luggage rack.

Gen2 (current) Extension plate fits both on Gen2 rack (current) and Gen1 rack (discontinued).

I. Video instructions

Adam Chandler made a great installation video for Gen1 Extension plate. 

II. Written instructions

With Gen2 Extension plate shown. 

In order to install the Extension plate Gen2 you must have Perun moto Husqvarna 701 Luggage rack installed - Gen1 or Gen2. 

1. Prepare the Extension plate and the hardware. 

2. Place the Extension plate over the rack, as shown. Gen 2 rack is shown here, but it will work for the Gen1 rack too, due to the slotted holes on the Extension plate. 

3. Insert the bolts from above and use washers and safety nuts on the underside. Align the Extension plate with the rack and tighten all bolts. 

---

III. Installation of Givi/Kappa Monokey Top case on Gen2 Extension plate

Road only use, 5 kg max (inside the top case).

1. Following hardware is needed and it can be purchased from Givi dealers.

• Z2710 (rubber grommets)

• Z125 (mushroom shaped parts)

• Z124 (pyramid shaped part)

2. Additional standard hardware is needed and it can be purchased in every hardware store. Zinc coated. 

• 2 x M6x16 button head bolt,

• 2 x M6x30 countersunk bolt,

• 6 x small M6 washer,

• 2 x M6 safety nut.

...

Almost all aforementioned hardware is sold by SW-Motech too, as a kit - HERE.

Also, all aforementioned hardware, except Z2710 grommets, are sold by Givi as a kit -  Givi Z2309R

3. Position the mushroom shaped parts in the marked locations.

IMPORTANT: Insert M6 small washer under each mushroom shaped part. Place the washer in the smaller circular pocket, as shown bellow.

Insert M6x30 countersunk bolt from above and use a washer and a safety nut on the underside.

4. Install the pyramid shaped part in the location marked bellow.

Cavity on the pyramid shaped part should face forward. Use small M6 washers and M6x16 button head bolts on the underside. 

5. Insert rubber grommets as shown bellow. Make sure the rubber grommets are properly seated. Use a drop of super glue to make sure grommets will stay in place.

6. Install Givi or Kappa Monokey top case. Make sure everything clicks in place. Check if top box is firm and secure.

---

IV. Installation of SW-Motech Top case on Gen2 Extension plate

Road only use, 5 kg max (inside the top case).

1. SW-Motech Adapter kit for Trax needed (purchased separately).

2. Position the mounting pucks in the marked spots. 

Be sure to add a wide M6 washer (purchased separately) into large circular pockets, underneath each puck. Top case will not sit properly without the washers.

Do not overtighten the bolts, as plastic covers can be deformed. Puck should sit in the circular pocket.

3. Install the sheet metal part as shown below. Use washers and safety nuts on the underside. Tighten by hand for now.

4. Install the top case and the close the top box latch. Let the sheet metal piece find its position. Remove the top case and tighten sheet metal part.

5. Install SW-Motech top case. Make sure everything clicks in place. Check if top box is firm and secure. If needed, readjust the position of sheet metal flange.