You are currently browsing Perun moto international store. If you are from the EU, please visit www.perunmoto.eu---

AWAY NOTICE - we will be out of office from June 22nd till July 4th. No packages will be shipped in this period. ---

    0

    Your Cart is Empty

    Perun moto Upper handlebar clamp 38/40x90 AMPS - Installation Instructions

    Fits on majority of KTM and Husqvarna motorcycles with 38x90 or 40x90 bolt pattern - KTM 690 Enduro and SMC-R, Husqvarna 701 Enduro and Supermoto (fits on BRP sub-mounts too!), GasGas ES/SM 700, KTM 790 and 890 Adventure, KTM 1x90 Adventure bikes, Husqvarna 901 Norden and many more. 

    Content of the kit

    • 1 x Upper handlebar clamp 38/40x90 AMPS 
    • 4 x M8x30 allen head bolt

    1. Remove stock left and right upper handlebar clamp. Make sure to mark the position of the handlebars (tilt). When you remove upper handlebar clamps, handlebars will probably move a bit. 

    Perun moto Upper handlebar clamp 38/40x90 AMPS - Installation Instructions - 1Perun moto Upper handlebar clamp 38/40x90 AMPS - Installation Instructions - 2

    2. Install Perun moto Upper handlebar clamp (UHC 38/40x90 AMPS). It can be installed facing towards the windscreen or towards the rider. As shown on photos. 

    Use provided M8x30 allen head bolts. 

    Use some thread-locker (Loctite 243 or similar).

    Perun moto Upper handlebar clamp 38/40x90 AMPS - Installation Instructions - 3Perun moto Upper handlebar clamp 38/40x90 AMPS - Installation Instructions - 4

    3. Position the handlebars and hand tighten the bolts. 

    Make sure the gaps on the front are same as the gaps on the rear! Tighten bolts evenly. Tighten up to 10 Nm. 

    Perun moto Upper handlebar clamp 38/40x90 AMPS - Installation Instructions - 5

    3. After some time, re-tighten to spec. 

    Use threaded M4 holes to install GPS or phone mounts.