Perun moto KTM 390 Adventure R or X / Enduro AuxPox Supports - Installation Instructions
Content of the kit
- 2 x AuxPox Support (LHS and RHS)
- 2 x Spacer plate
- 8 x M6x20 buttonhead bolt
- 2 x M6x30 buttonhead bolt
- 2 x M6x25 countersunk bolt
- 4 x M8x60 countersunk bolt
- 10 x M6 flat washer
- 10 x M6 wide flat washer
- 10 x M6 safety nut
---
Step-by-step video instructions.
Coming soon.
---
I Installation of the Aux-Pox Supports
Note: Perun moto KTM 390 Adventure AuxPox Supports are not a standalone product. They can only be installed with the KTM 390 Adventure R/X/Enduro Top luggage rack.
Required tools:
- 4mm Allen key
- 5mm Allen key
- 10mm wrench / socket
1. Remove the two M8 bolts and two M6 nuts and bolts from our top rack, circled with red in the photo below. One M6 nut and safety washer will be reused. Be careful not to lose the four spacers which are held in place with these M8 bolts.
Orientation of the parts matters. RHS Spacer plate should be oriented as shown. Perun Moto logo on the AuxPox Support plate needs to be right-side up.
2. Pre-assemble the AuxPox Support plate and Spacer plate by inserting two M8x60 countersunk bolts through both parts.
3. Align the bolts with mounting holes on the top rack side brackets. Ensure all spacers are in their place and tighten the bolts by hand.
4. Use M6x25 countersunk bolt and reuse M6 safety nut and flat washer removed in step 1 to secure rear of the AuxPox Support.
5. Once everything lines up correctly, tighten the M6 bolt to 6-7Nm and M8 bolts to 18Nm.
6. Repeat the process on the other side of the bike.
7. After a few rides check the bolts and retighten if needed.