Perun moto Yamaha Tenere 700 Tie-down brackets Gen 2 - Installation Instructions
Content of the kit
- 2 x Tie-down bracket (LHS and RHS)
- 4 x M8x20 button head TX bolt
- 4 x M8 flat washer
---
Step-by-step video instructions.
---
I Installation of the Tie-down brackets Gen 2
Required tools:
- 6mm Allen key
- TX-40
1. Remove stock passenger foot peg brackets. Undo the two bolts per side and remove the brackets.
2. Clean the threaded holes.
3. Install the RHS Tie-down bracket Gen 2, as shown. Use provided M8x20 button head bolts and M8 flat washers from the underside.
Use thread-locker (Loctite 243 or similar). Torque to 8-10 Nm.
4. Repeat on the other side.
5. After few rides, re-torque to spec if needed.