Perun moto KTM 390 Adventure R or X / Enduro OS-Base support - Installation Instructions
Content of the kit
- 2 x OS-Base Support (LHS and RHS)
- 4 x M8x60 countersunk bolt
- 4 x M8 countersunk 3D washer
---
Step-by-step video instructions.
Coming soon.
---
I Installation of the OS-Base Supports
Note: Perun moto KTM 390 Adventure OS-Base Supports are not a standalone product. They can only be installed with the KTM 390 Adventure R/X/Enduro Top luggage rack.
Required tools:
- 5mm Allen key
1. Remove the two M8 bolts from our top rack, circled with red in the photo below. Be careful not to lose the four spacers which are held in place with these bolts.
2. Insert two M8x60 countersunk bolts and two 3D countersunk washers trough mounting holes on the LHS OS-Base Support.
3. Align the bolts with mounting holes on the top rack side brackets. Ensure all spacers are in their place and tighten the bolts by hand.
4. Once everything lines up correctly, tighten the M8 bolts to 18Nm.
5. Repeat the process on the other side.
6. After a few rides check the bolts and retighten if needed.