Extension Plate for Perun moto KTM 390 Adventure R, X or Enduro Luggage rack - Installation Instructions

Extension Plate for Perun moto KTM 390 Adventure R, X or Enduro Luggage rack fits only Perun moto KTM 390 Adventure R, X or Enduro Luggage rack.

Content of the kit

• 1 x Extension plate
• 4 x M6x20 countersunk bolt
• 4 x M6 safety nut
• 4 x M6 flat washer

---

Step-by-step video instructions.

Coming soon. 

---

I Installation of the rack

II Installation of Givi/Kappa Monokey Top case

III Installation of SW-Motech Top case

---

I Installation of the rack

Required tools:

• 4mm Allen key
• 10mm wrench

In order to install the Extension plate you must have Perun moto KTM 390 Adventure R, X or Enduro Luggage rack installed. 

1. Place the Extension plate over the rack and align mounting holes with holes on the rack. 

2. Insert the bolts from above and use washers and safety nuts on the underside. Align the Extension plate with the rack and tighten all bolts. 

---

II. Installation of Givi/Kappa Monokey Top case on Extension plate

Road only use, 5 kg max (inside the top case).

1. Following hardware is needed and it can be purchased from Givi dealers.

• Z2710 (rubber grommets)

• Z125 (mushroom shaped parts)

• Z124 (pyramid shaped part)

2. Additional standard hardware is needed and it can be purchased in every hardware store. Zinc coated. 

• 2 x M6x16 button head bolt,

• 2 x M6x30 countersunk bolt,

• 6 x small M6 washer,

• 2 x M6 safety nut.

...

Almost all aforementioned hardware is sold by SW-Motech too, as a kit - HERE.

Also, all aforementioned hardware, except Z2710 grommets, are sold by Givi as a kit -  Givi Z2309R

3. Position the mushroom shaped parts in the marked locations.

IMPORTANT: Insert M6 small washer under each mushroom shaped part. Place the washer in the smaller circular pocket, as shown bellow.

Insert M6x30 countersunk bolt from above and use a washer and a safety nut on the underside.

4. Install the rear attachment clamp as shown. Cavity should face forward. Use small M6 washers and M6x16 button head bolts on the underside.

5. Insert rubber grommets as shown bellow. Make sure the rubber grommets are properly seated. Use a drop of super glue to make sure grommets will stay in place.

6. Install Givi or Kappa Monokey top case. Make sure everything clicks in place. Check if top box is firm and secure.

---

III. Installation of SW-Motech Top case on Extension plate

Road only use, 5 kg max (inside the top case).

1. SW-Motech Adapter kit for Trax needed (purchased separately).

2. Position the mounting pucks in the marked spots. 

Do not overtighten the bolts, as plastic covers can be deformed. Puck should sit in the circular pocket.

3. Install the sheet metal bracket as shown below. Use washers and safety nuts on the underside. Do not fully tighten the bolts at this time. The bracket should still be able to move slightly.

4. Install the top case and the close the top box latch. Let the sheet metal bracket find its position. Remove the top case and tighten the two bolts.

5. Install SW-Motech top case. Make sure everything clicks in place. Check if top box is firm and secure. If needed, readjust the position of sheet metal flange.